Vender 2.4G GPS RC Transmitter Receiver Kit for RC Bait Tug Fishing Boat Fixed Speed Cruise e Radio System Remote Controller al mejor precio

Receiver board adaptable battery: 6V, 7.2V, 7.4V, 11.1V, 12V lithium battery pack. Do not use dry batteries. The poor current output capability of dry batteries will cause the motor fail to start; the maximum withstand voltage is 15V. Receivier board adaptable motor: 380, 390, 550 and other motors. The maximum output current of each channel of the receiving board motor driver is about 10A, which can drive small and medium-sized motors with load currents within 10A. Motor interface: single channel rated current 10A, peak current 22A. LED lamp interface: directly connect to the LED light, resistance of 200 ohm has been connected in series inside the circuit board; Servo interface: common servos can be used (such as 995); Remote controller: One-handed remote control use 2 x AAA batteries (battery not include) Remote control channel: front, rear, left and right directions, LED light control, constant speed cruise, left bait silo, right bait silo, constant speed cruise speed increase and decrease. go to the fishing site, return to starting point; Product highlights:Built-in compass can realize straight-line driving; Constant speed cruise function, easy to operate, no need to keep moving the handle. Built-in GPS, can achieve constant speed cruise, low battery or without control signal automatic return The angle of the steering gear can be set, and it can be used to control single or double compartments. Two-way communication, buzzer will remind after the control command is successful; Over-current protection, prevent the motor from burning down due to blocking, winding, etc; 2 steering gear and geared motor interfaces are reserved for easy adaptation Convenient to replace the mainstream nesting boats on the market come with their own remote control kits, which can be used as repair parts, DIY bait boats, and traditional bait boats (without gyroscope) upgrades Note: 1.The remote controller and the receiving board should be used together,it cannot be matched with other manufacturers.2.The wireless transmitting signal is strong.The distance between the remote control and the control board should be greater than 20cm when using.3.Recommend using 7.4V rechargeable battery,390 motor,high-speed motors with a working current greater than 10A are not recommended.4.The mainboard chip built-in compass,please click on the main board on the back of the tip in the direction of the installation,so the hull can realize automatic line. Factors that easily cause the mainboard to burn: 1.Use high-voltage and high-rate battery (such as 12V) and drive a high-speed and high-power motor (load current is greater than 8A),which may cause the mainboard to burn out due to overpower or overheating. 2.When using high-voltage high-rate battery to drive high-power motor,quickly move the handle back and forth to switch the motor forward and reverse,causing overcurrent and overheating of the motherboard to burn. 3.The positive and negative poles are reversed when ifying or welding the power cord. 4.The input voltage exceeds the maximum withstand voltage. 5.RC boat cabin flooding. Remote control distance: 500 meters Remote controller power consumption: 21mA Receiver board power consumption: 130mA colour: black Material: plastic Package Contents: 1 x remote controller 1 x receiver Only the above package content, other products are not included. Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.