Vender Holybro F4 V2 Flight Controller With Betaflight OSD RC Racing Drone Upgrade al mejor precio
0
calificaciones
63.987 CLP
49% OFF
32.401 CLP
Se envía desde |
---|
Descripción del producto
Description:
The Kakute F4 flight controller supports important features of Betaflight/Cleanflight, such as OSD and Dshot.
The Kakute F4 is designed to support all serial protocols at once.
Specification:
MCU: STM32F405RGT6 32-bit processor
IMU: ICM20689 (SPI)
Barometer: BMP280
USB VCP Driver (all UARTs usable simultaneously; USB does not take up a UART)
5 hardware UARTS (UART1,3,4, 5, 6)
Supports serial receivers (SBUS, iBus, Spektrum, Crossfire) only. PPM and PWM receivers are not supported.
128 Mbit Dataflash chip for Blackbox logging
Mounting Holes: Standard 30.5mm square to center of holes
-Additional UART (UART 4) added to support serial camera communication such as to Split. Please note this is NOT
the same as Betaflight Camera Control feature, which controls the menu of FPV cameras like Swift, etc.
-Additional UART (UART 5) added to support ESC telemetry such as from BLHeli_32 and KISS.
-Through-hole solder pads instead of flat pads for more secure soldering especially for beginners.
-Barometer sensor on board allows altitude hold mode.
-I2C pad available for certain external sensors.
Size Chart:
Dimensions: Approx. 35x30x8mm/ 1.38x1.18x0.3 in (includes USB in height)
Package Includes:
1 Pieces F4 Flight controller
Note:
Due to manual measurement, there may be 1-2cm error in size