Vender PLHNFS Motor Controller 12V-36V 500W Brushless DC Motor Balanced Car Driver Board al mejor precio

#Motor #Controller #12V-36V #500W #Brushless #DC #Motor #Balanced #Car #Driver #Board Motor Controller 12V-36V 500W Brushless DC Motor Balanced Car Driver Board Features: 100% brand new and high quality When the potentiometer control wiring, the potentiometer middle pin is connected to VR speed port, potentiometer connected to both ends of 5V and GND terminal voltage higher speed faster This driver board has many advantages including low consumption, high reliability and efficiency. Pulse speed signal: high and low output . IC can not understand the information with the customer request This board has many functions such as stall protection, enable control, over-current protection, steering control and speed control signal. Motor driver board 12-36V DC power input , VCC positive power supply,GND power supply is negative. Specification: Operating voltage: DC 12V-36V Operating Current: <=15A Driver Power: <=500W Speed Voltage: 0.1V-5V Operating Temperature:-40-85C Humidity: 90%RH Stall protection:Yes Enable Control: Yes Over-current protection: Yes Steering control: Yes Speed control signal: Yes Size: 63x42x17mm/2.48x1.65x0.67in Power terminal Out: VCC(positive power supply) GND(negative one) MC(motor phases W) MB(motor phases V) MA(motor phase U) Set for the control side: GND control terminal ground VR the governor end 0-5V ZF reversing control M tachometer pulse output EL enable control terminal 5V 5V control terminal Package Includes: 1x 12-36V 500W Brushless Motor Controller note: Due to the problems of lighting effects and shooting angles, there will be certain tolerances in the product, please understand. Please allow 0-1cm error due to the manual measurment. Due to different motor manufacturers to make the hall of hall line order does not necessarily follow the line on the board to match the sequence, need to be adjusted, please parents who pay attention! If the line sequence wrong, does not boot properly, current, or start other phenomena not open, forced to use the drive plate will burn!!!